Draw Spike In Foundry
The draw spike is a pointed steel rod, with a loop at one end. These foundry tools are used to rap and draw patterns from the sand. Fig.
11.46 illustrates two kinds of draw spikes. In molding shop, it is used for driving the draw spike into the pattern and then rapping it for separation from the mould surfaces so that pattern can be easily withdrawn leaving the mold cavity without damaging the mold surfaces. Draw spike Draw spike is a tapered steel rod having a loop or ring at its one end and a sharp point at the other.
Foundry - Tools - Mechsolutions
Learn how to make molds for casting metal using sand, clay, and various tools. Find out what draw spikes are and how to use them for drawing wooden patterns from the sand. DRAW SPIKE Draw spike: Draw spike is shown.
It is a tapered steel rod having a loop or ring at its one end and a sharp point at the other. It may have screw threads on the end to engage metal pattern for it withdrawal from the mold. It is used for driven into pattern which is embedded in the molding sand and raps the pattern to get separated from the pattern and finally draws out it from the.
Foundry Training Equipments Civil Engineering TVET Lab Equipments ...
An improved Draw Spike Discussion in ' Foundry tools and flasks ' started by Melterskelter, Aug 8, 2019. 1.13 Draw spike (screw) Draw spike are used to lift the pattern from the sand mould. Two types of draw spike are shown in the figure.
Draw pin is inserted into a wooden pattern while thread end of draw spike screws into a wooden pattern draw plate fastened to the large wooden plate or tapped hole of metal pattern. 1.14 Rapping plate. The document lists and describes various tools used in foundry operations such as mold making.
Foundry - Tools - Mechsolutions
It discusses 18 different tools including hand tools like rammers, shovels, and riddles used to prepare and condition sand. Pattern withdrawal tools like draw spikes, vent rods and gates cutters are described. Finishing tools like trowels, slicks and smothers are used to refine mold surfaces.
This document describes various hand tools used in foundry shops for molding operations. It discusses common tools such as hand riddles, shovels, rammers, sprue pins, strike off bars, mallets, draw spikes, vent rods, lifters, trowels, slicks, smoothers, swabs, gate cutters, gaggers, spray guns, and nails. These hand tools are used for tasks like cleaning sand, mixing and transporting sand.
It is a tapered steel rod having a loop or ring at its one DRAW SPIKE 13 end and a sharp point at the other. It may have screw threads on the end to engage metal pattern for it withdrawal from the mold. Draw Spike Draw spike are used to lift the pattern from the sand mould.
Two types of draw spike are shown in the figure. Draw pin is inserted into a wooden pattern while thread end of draw spike screws into a wooden pattern draw plate fastened to the large wooden plate or tapped hole of metal pattern. Foundry Forging & Welding Laboratory 18MEL38B.
